Make:
Mazda
Model:
RX-7
Country:
USA
Region:
CA
City:
Los Angeles
Zip:
90065
Body Style:
Coupe
Year:
1993
Mileage:
153456
Miles
Transmission:
Manual
Fuel:
Gasoline
Doors:
2
Color:
Yellow
Condition:
Used
Engine: 13brew street ported (1,000 miles) built by
2 mm Apex Seals
Exedy 12lb Lightweight Flywheel
Greddy T-78 Kit Brand New with slight oversize billet compressor wheel blueprinted with 1k miles
Greddy Type RS Blow Off Valve
Greddy 3 Row Front Mount Intercooler
Magnecor R-100 Plug Cables
550cc primary / 1680 Bosch secondary injectors RC Engineering cleaned & blueprinted
Aeromotive Fuel Pressure Regulator
GM 3-bar MAP sensor
Denso/Supra Fuel Pump
Fuel Filter Relocation
Koyo Race Radiator Brand New
Aluminum AST Brand New
Earl’s 34 Row Dual Oil Coolers (SS lines) Brand New
Resonated Midpipe
Apexi N1 Racing Exhaust (w/ silencer)
Removed A/C & Power Steering
The OMP (oil metering pump) system has been deleted and is now running on Idemitsu Racing pre-mix (1/2 quart per 93 fill-up)
I still have the OMP pump and the lines if the new owner wants them.
Powertrain:
Spec clutch stage 3 6 puck
KAAZ 1.5 Limited Slip Differential
OEM rebuild 5 speed (no sychro problems!)
New OEM Power plant frame (properly aligned)
JimLab Differential Delrin Bushings
B&M Short Shifter
Suspension:
Apex’I N1 Coilovers
JimLab Complete Bushing Kit
Upgraded Front & Rear Sway Bars
New OEM Front Sway Bar Mounts
RP Trailing Arms Launch Kit
RP Toe Links
Autopower 4-Point Roll Bar
Brakes:
Bonez Cross Drilled Front Rotors
Hawk Black front Pads
Slotted stop tech rotors and pads in the rear
replaced all rear wheel studs with ARP extended studs
replaced both rear wheel bearings
Electronics:
Apex’I Power FC w/ FC-Commander and FC-Datalogit
Greddy Profec B Boost Controller
HKS Turbo Timer
Innovate Wideband O2 + Gauge
Defi Link Gauges (Water Temp, Fuel Pressure, Boost)
Radio is aftermarket cd player and works well
The blower motor does work as well so does the heat
The drivers seat has a small tear in the bolster
The drivers carpet has a small tear where heel/toe down shifts
The arm rest where your right elbo would rest has very small tear
Exterior:
C West carbon fiber projector Headlights
Feed Front Bumper
Knightsports Carbon Fiber Hood
C-West Rear Bumper
factory R1 spoiler (has a small crack top center)
Veilside D1-GT Side Skirts
Super Advan Racing II Wheels (F: 18x8.5 +45 / R: 18/9.8 +38)
2 mm Apex Seals
Exedy 12lb Lightweight Flywheel
Greddy T-78 Kit Brand New with slight oversize billet compressor wheel blueprinted with 1k miles
Greddy Type RS Blow Off Valve
Greddy 3 Row Front Mount Intercooler
Magnecor R-100 Plug Cables
550cc primary / 1680 Bosch secondary injectors RC Engineering cleaned & blueprinted
Aeromotive Fuel Pressure Regulator
GM 3-bar MAP sensor
Denso/Supra Fuel Pump
Fuel Filter Relocation
Koyo Race Radiator Brand New
Aluminum AST Brand New
Earl’s 34 Row Dual Oil Coolers (SS lines) Brand New
Resonated Midpipe
Apexi N1 Racing Exhaust (w/ silencer)
Removed A/C & Power Steering
The OMP (oil metering pump) system has been deleted and is now running on Idemitsu Racing pre-mix (1/2 quart per 93 fill-up)
I still have the OMP pump and the lines if the new owner wants them.
Powertrain:
Spec clutch stage 3 6 puck
KAAZ 1.5 Limited Slip Differential
OEM rebuild 5 speed (no sychro problems!)
New OEM Power plant frame (properly aligned)
JimLab Differential Delrin Bushings
B&M Short Shifter
Suspension:
Apex’I N1 Coilovers
JimLab Complete Bushing Kit
Upgraded Front & Rear Sway Bars
New OEM Front Sway Bar Mounts
RP Trailing Arms Launch Kit
RP Toe Links
Autopower 4-Point Roll Bar
Brakes:
Bonez Cross Drilled Front Rotors
Hawk Black front Pads
Slotted stop tech rotors and pads in the rear
replaced all rear wheel studs with ARP extended studs
replaced both rear wheel bearings
Electronics:
Apex’I Power FC w/ FC-Commander and FC-Datalogit
Greddy Profec B Boost Controller
HKS Turbo Timer
Innovate Wideband O2 + Gauge
Defi Link Gauges (Water Temp, Fuel Pressure, Boost)
Radio is aftermarket cd player and works well
The blower motor does work as well so does the heat
The drivers seat has a small tear in the bolster
The drivers carpet has a small tear where heel/toe down shifts
The arm rest where your right elbo would rest has very small tear
Exterior:
C West carbon fiber projector Headlights
Feed Front Bumper
Knightsports Carbon Fiber Hood
C-West Rear Bumper
factory R1 spoiler (has a small crack top center)
Veilside D1-GT Side Skirts
Super Advan Racing II Wheels (F: 18x8.5 +45 / R: 18/9.8 +38)
Email
Share
Report
Favorite
Add to Compare
